Rose Quartz is a crystal of unconditional love, it’s the perfect stone to help you attract romance, love, and soulmate into your life. Pull the clasp ends of the chain through the loop and pull tight to make the slip knot.70% of profits go to poor Tibetan children Slide that loop through the top of the pendantĩ. Once it’s off, we’re going to make a slip knot, so hold the center loop between your thumb and pointer finger like this.Ĩ. Hold onto the center, you could tape it to hold it in place if you’d like, and slip off the necklace. Put on your necklace and note the center (to do this place the clasp on the center-back of your neck). Do the same on the 11″ side but before closing the jump ring, slip the spring clasp onto the jump ring then close the ring.ħ. Using your awesome newfound chain/jump ring skills, slip a jump ring onto the 17″ side. Onto the clasp! This is what will hold this dainty little darling on your neck. When you’re done you should have a tag connecting your two pieces of necklace chainĦ. Now repeat steps 3 & 4 on the left side of the tag using the end of the 17″ chain. Once the chain and the tag are both on the jump ring, squeeze the ring firmly closed with pliers.ĥ. Now the tough part, take the end of your chain and very gently thread the jump ring through the last link in the 11″ chain (it’s like threading a needle). ![]() Thread a jump ring through the right hole in your stamping blank.Ĥ. I wanted a nice long necklace so I cut one stretch of chain at 17″ (about 3 inches of this chain will wrap to the other side), and an 11″ stretch of chain. Also it’s time to measure out your necklace chain. Now begins the necklace fun! Time to prep – using the pliers (it helps if you have two sets of pliers) open up your jump rings. Fun fact: Rose Quartz is supposed to represent love and draw love into your life. I highly, highly recommend that you practice stamping on some scrap metal before you commit to your stamping blank.Īfter getting a few rounds of practice in, it’s time for the real thing! You can tape down your teeny tiny blank to the stamping block (I actually recommend it) and get to work! Note: The stamping blanks will curl up a bit at the edges if you stamp them too hard, so just give them two taps (one quick light one, one slightly harder tap).Ģ. Let’s start with the stamping – I wanted a little “Love” tag on my necklace chain like the necklace I modeled this off of (you can totally skip this part).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |